Mitsubishi FX1N Series Programming Manual

FX Series Programmable Controlers Applied Instructions 5
5-20
5.2.3 MOV (FNC 12)
Operation:
The contents of the source device (S) is copied to
the destination (D) device when the control input is
active. If the MOV instruction is not driven, no
operation takes place.
Mnemonic Function
Operands
Program steps
SD
MOV
FNC 12
(Move)
Moves data from
one storage area
to a new storage
area
K, H,
KnX, KnY, KnM, KnS,
T, C, D, V, Z
KnY, KnM, KnS,
T, C, D, V, Z
MOV, MOVP:
5steps
DMOV,
DMOVP:
9steps
FX 1S
FX 1N FX 2N
FX 2NC
PULSE-P 16 BIT OPERATION 32 BIT OPERATION
Flags
Zero M8020
X0
MOV
H0050
D 10
[ S ] [ D ]
Note: This instruction has a special programming technique which allows it to mimic the
operation of newer applied instructions when used with older programming tools. See page
1-5 for more details.

Mitsubishi FX1N Series Specifications

General

Programming Language	Ladder Logic
Output Type	Relay, Transistor
Operating Temperature	0 to 55°C
Power Supply	100-240V AC or 24V DC
Program Capacity	8K steps
Communication Ports	RS-422
Data Memory	8000 words
High-speed Counters	Up to 6 channels
Expansion Modules	Available
Pulse Output	2 points