Mitsubishi FX1N Series Programming Manual

FX Series Programmable Controlers Applied Instructions 5
5-120
c) The PRUN instruction enables data to be moved into the bit transmission area or out of the
(bit) data received area. The PRUN instruction differs from the move statement in that it
operates in octal. This means if K4X20 was moved using the PRUN instruction to K4M920,
data would not be written to M928 and M929 as these devices fall outside of the octal
counting system. This can be seen in the diagram below.
d) For more information please see page 9-6.
M936 M935 M934 M933 M932 M931 M930 M927 M926 M925 M924 M923 M922 M921
X37 X36 X35 X34 X33 X32 X31 X30 X27 X26 X25 X24 X23 X22 X21 X20
K4X20
K4M920
M937 M920
M928M929
These devices are not written to with
the PRUN instruction

Mitsubishi FX1N Series Specifications

General

Programming Language	Ladder Logic
Output Type	Relay, Transistor
Operating Temperature	0 to 55°C
Power Supply	100-240V AC or 24V DC
Program Capacity	8K steps
Communication Ports	RS-422
Data Memory	8000 words
High-speed Counters	Up to 6 channels
Expansion Modules	Available
Pulse Output	2 points