WAT E R SYSTEMS - 6
CAY M A N 2 0 0 7
121
To Attach the Hose:
Remove sewer hose from carrier.
Unscrew the access deck plate and feed
the drain hose through the opening.
Remove termination cap. Align coupler
tangs with termination tabs. Twist
coupler clockwise 90º to lock the coupler
to the termination outlet.
Attach the other end of the hose to the
drain service. Restrain hose to prevent
movement during use.
Open the grey water valve.
The black water valve remains closed until
the tank is full or until time of departure to help
prevent clogging. Use the outside faucet or
shower attachment for washing or rinsing the
sewer hose after dumping the black tank.
LUBE:
Lubricate the O-ring on the sewer hose
adapter periodically with silicone spray.
NOTE:
Close the grey water valve 24 hours
prior to departing to allow the tank to
fill with liquid to help in the dumping
process.
NOTE:
Use care when connecting the sewer
hose adapter to the termination outlet in
cold weather.
Tank Flush
The motorhome comes equipped with a power
ush nozzle, located in the black tank to help
reduce solid build-up. Flush the tank each drain
cycle. Failure to thoroughly rinse the black tank
may result in accumulated solids and a clogged
spray nozzle.
Dumping the Tanks:
1. Close the grey water valve.
2. Fill the grey tank to at least 50% by
running water in the shower or sinks.
3. Use the tank monitor in the service bay
to observe tank levels. Stop lling the
tank when the grey tank is half full.
4. Open the black water valve, and allow
the black tank to drain.
5. Connect a non-potable water hose, with
pressure regulator, to the ush system
tting located in the service center.
6. Turn on the faucet and allow water to
rinse the black tank for at least three
minutes. Never operate the system
unattended. Ensure water ows freely
though the drain hose.
7. Turn off the faucet and close the black
water valve when completed.
8. Open the grey water valve. The water
in the grey tank will ush remaining
solids from the hose. The grey valve
remains open until the next drain cycle
or time of departure.
WARNING:
Never operate the flush system
unattended. Flooding may occur. Use
the tank flush system each time the
holding tanks are cycled. Failure to
routinely use the flush system will result
in a clogged spray nozzle. Turn off the
water supply when finished flushing the
tank.
9. Close both valves when preparing for
travel. Undo restraining devices from
the hose. Disconnect the hose from
the termination outlet by rotating the
tting counterclockwise 90º.
10. Install sewer hose in carrier and lock
door.
11. If desired, add chemicals to the tanks
to control odor. Follow the directions
given by the manufacturer of the
chemical.
NOTE:
Dump the black tank before traveling.
040422g
040460s
To Next Page