APPLIANCES - 4
CAY M A N 2 0 0 7
83
Setting the Clock
To Set the Clock:
Press the STOP/CLEAR button.
Press the CLOCK button.
Enter the time using the number buttons.
Press the CLOCK button to start time.
NOTE:
The clock is a 12 hour clock only.
Care & Cleaning
The exterior of the microwave/convection
oven is plastic and metal. The interior is metal.
DO NOT clean with scouring pads, harsh
or abrasive cleaners, chemical cleaners or
petroleum based thinners that can damage the
nish. Use mild soap and water with a damp
cloth or paper towel to remove stains or spills.
When cleaning the touch pad, open the door
to prevent accidental operation. Use mild
soap and water with a soft cloth. Avoid using
excess amounts of water on the touch pad. The
turntable plate and oven racks are dishwasher
safe.
Charcoal Filter:
Depending on use, the charcoal lter should
be replaced every 6 to 12 months. Use the
following procedure to remove the louvers to
replace the charcoal lter and oven light:
1. Remove power to the microwave/
convection oven.
2. Remove the screws (A) securing the
louver.
3. Insert a at edge screwdriver over each
tab pressing downward and move the
louver away from the microwave.
4. Remove and replace the charcoal lter.
Ensure the lter is positioned on the
supporting tabs.
5. Replace louver and mounting screws.
Oven Light:
1. Remove the louver as indicated above.
2. Slide the metal light cover forward and
lift upwards.
3. Remove the light bulb and replace
only with an equivalent watt bulb. DO
NOT EXCEED 30 WATTS.
4. Replace light cover, louver and
mounting screws.
Hood Light:
1. Remove power to the microwave/
convection oven.
2. Remove the screw (B) securing the
light cover.
3. Remove the light bulb and replace
only with an equivalent watt bulb. DO
NOT EXCEED 30 WATTS.
4. Close the cover and re-secure with
screw.
CAUTION:
Light cover may be hot. DO NOT touch
glass with lamp ON. Never use the light
for prolonged periods, such as a night
light.
Grease Filters:
Operating the microwave/convection oven
without the grease lters in place can damage
the unit. Grease lters should be cleaned at
least once a month. To remove the lters, use
the pull-tab to slide the lter to the end of the
opening and tip down. Soak the lters in the
sink or in a dishpan lled with hot water and
detergent.
DO NOT use ammonia or other alkali-
based products that may darken the lter
material.
Agitate the lter. Use a scrub brush to
remove caked on grease.
Rinse the lter thoroughly and shake dry.
Place the lter back into the opening, tip
upward and slide lter to the end of the
opening. Lock in place. Be careful not to
kink or warp the lter upon installation.
031106c
To Next Page
Loading...
