APPLIANCES - 4
CAY M A N 2 0 0 7
86
Set the oven control knob to “Pilot On”
to maintain pilot ame. The oven and
broiler are now ready for operation.
The oven pilot has been factory set and
requires no further adjustment.
To extinguish the oven pilot push in the
oven control knob and rotate clockwise
to “Off.”
WARNING:
Extinguish all pilots when refueling
or traveling. DO NOT block vents in
oven with cookware or other objects.
WALL THERMOSTAT
The comfort control
operates the HVAC
(Heating, Ventilating
and Air Conditioning)
system. The comfort
control is located in
the hallway on the
monitor panel, and
uses a liquid crystal
display to show the
current mode status.
Five different modes of the Comfort
Control system:
Off, Fan, Cool, Heat Pump (optional) and
Furnace. These are selected by repeat pressing
of the Mode button. The Fan button controls
the fan speed of the roof air conditioner. Low
and high fan speed control applies only to
the blower speed of the roof air conditioner.
Selecting the fan speed “Auto” adjusts the fan
speed automatically, depending on temperature
set point and actual temperature in a selected
zone.
The motorhome is divided into two operating
zones. The living room is Zone 1, and the
bedroom is Zone 2. The comfort control must
be in Zone 1 for the furnace to operate unless
the motorhome is equipped with two furnaces.
For oorplans with two furnaces, Zone 1 will
operate the living
room furnace and
Zone 2 will operate
the bedroom furnace.
Press the Zone
button to change
zones. The selected
zone will ash.
The up and down
buttons control the
temperature in any
mode.
NOTE:
The Comfort Control must be on to
operate any HVAC function.
NOTE:
The motorhome will not heat or cool
faster by selecting a very high or very
low temperature setting.
NOTE:
Conflicting modes cannot be selected.
One zone cannot be set to heat mode
while another zone is set to cool mode.
Fan Operation:
Interior air is circulated using the roof air
conditioner blower. The fan speed controls
the roof air conditioner blower speed in the
following modes: Fan, Cool or Heat Pump.
Slide the On/Off switch (on hallway
thermostat) to the On position.
Press the Mode button repeatedly until
Fan is displayed.
Press the Fan button to select fan speed.
Air Conditioner Operation:
Slide the On/Off switch (on hallway
thermostat) to the On position.
Press the Zone button to select Zone
1 (front roof A/C) or Zone 2 (rear roof
A/C).
Press the Mode button repeatedly until
Cool is displayed.
Select fan speed by pressing the Fan
button.
Set desired cooling temperature in each
Zone by pressing Up and Down buttons.
Furnace Operation:
Slide the On/Off switch (on hallway
thermostat) to the On position.
Press the Zone button to select Zone
1 (some oorplans include furnaces in
Zone 1 and 2).
Select the Furnace mode on the
Comfort Control using the Mode button.
Select the desired temperature using the
Up and Down arrow buttons.
050200b
030950
Remote Temperature Sensor
To Next Page
Loading...
