CHASSIS INFORMATION - 10
191
CAY M A N 2 0 0 7
CAUTION:
Prior to leveling the motorhome it is
important that all jacks be in contact
with the ground to stabilize and support
the frame. No single jack should be
solely used to level the motorhome.
Applying an improper leveling process
can cause excess torsion stress and/or
twisting of the chassis, frame and body,
resulting in damage to the windshield or
an entry door malfunction.
Extend the front jack(s) until contact
with the surface is made. Extend an
additional ½". This allows the front
jack(s) to act as a pivot point.
Extend the jack position according
to the indicator lamp. Example: If
the indicator lamp is lit under Jack
Extend Switch - Rear, the rear of the
motorhome is low. Press and hold the
Rear button. Both rear jacks will extend.
Once level, the system will automatically
stop. The Power Gear Level Light will
illuminate. Release the switch. Pressing
Right or Left will extend a single rear
jack accordingly.
Turn off the remote panel.
Turn off the Ignition switch.
Automatic Leveling
The automatic function of the leveling system
should only engage when the site is relatively
level and solid to prevent excessive twist/stress
to the frame. It is essential that there is no
movement in the motorhome prior to and during
the automatic leveling process.
Automatic Leveling Operation:
Follow the instructions in Prior to
Leveling.
Turn the ignition switch to On or ACC
position.
Press the ON/OFF button to turn the
system on.
Press the Auto switch. The pump motor
activates and the appropriate jacks
automatically extend and level the
motorhome.
NOTE:
A Jacks Down warning light will
illuminate when the jacks are extended.
The alarm will sound if the jacks are
down and the park brake is released or
transmission placed in gear.
The motorhome is level when the LED’s
next to Jack Extend switches are off
and the green Power Gear Level light is
illuminated.
Turn off the remote panel.
Turn off the ignition switch.
NOTE:
If additional height
or surface support
is needed, construct
a 1' x 1' wooden
block made from two
pieces of ¾" plywood
for a total thickness
of 1½". Drill a hole in
one corner and use the awning wand to
slide the wooden block under the jack
pad.
Retracting Leveling Jacks
Turn the ignition switch to On or ACC.
Con rm that parking brake is applied.
Turn On the remote panel.
Momentarily press the All Jacks Retract
button. If retracting in manual mode, the
All Jacks button must be held until the
Jacks Down LED goes out.
Once the Jacks Down LED goes out,
jacks should be fully retracted. Make a
visual inspection to ensure that all jacks
have fully retracted before moving the
motorhome.
INSPECTION:
Perform a visual inspection to ensure
that all jacks have fully retracted before
moving the motorhome. Remove any
debris that may be on the jack pad.
Wood Support Block
020185b
020185b
To Next Page