Motorola EP350

Radio Programming and Tuning: Front Panel Programming 5-19
TPL 2
**
067.0
067.1 ...
254.9
255.0
Non-standard private line (TPL) frequency.
67.0 Hz – 255.0 Hz with 0.1 Hz step.
TPL 3
**
067.0
067.1 ...
254.9
255.0
Non-standard private line (TPL) frequency.
67.0 Hz – 255.0 Hz with step size of 0.1 Hz.
RXDPL TY
**
(RX DPL Type)
CH-001 ...
CH-099
DPL
INV DPL (Invert DPL)
Receive DPL Type – DPL or Invert DPL.
TXDPL TY
**
(TX DPL Type)
CH-001 ...
CH-099
DPL
INV DPL (Invert DPL)
Transmit DPL Type – DPL or Invert DP.
RV BURST
**
(Reverse Burst)
CH-001 ...
CH-099
NONE
180
240
Reverse burst setting – None, 180° or 240°.
TOC
**
(Turn Off Code)
CH-001 ...
CH-099
ENABLE
DISABLE
Turn Off Code setting – enable or disable.
SQUELCH
(Squelch Level)
CH-001 ...
CH-099
NORMAL
TIGHT
NORMAL squelch level – receive weak signals.
TIGHT squelch level – receive strong signals and
eliminates unwanted noise.
TIME OUT
(Time
Out Timer)
OFF
010
020
...
590
600
Maximum duration (in seconds) the radio can
transmit continuously.
POWER
(Power Level)
CH-001 ...
CH-099
HIGH
LOW
Power level – High or Low.
PRIME CH
(Prime
Channel
OFF
001...
099
The channel that you wish to spend most of your
time monitoring.
The radio will always switch back to the Prime
Channel if it is idle for more than the
preprogrammed hang-time in other channels.
PR CH HT
**
(Prime Channel
Hang Time)
010
011...
059
060
Prime Channel Hang Time – duration the radio
will stay in another channel before reverting back
to the prime channel.
10 sec. – 60 sec. with step size of 1 sec.
BCL
**
(Busy Channel
Lockout)
CH-001 ...
CH-099
ENABLE
DISABLE
Busy channel lockout – enable or disable.
COPY CH
**
(Copy Channel)
CH-001 ...
CH-099
TO CH XXX Copy setting of a channel to a new channel.
SIGNALNG
**
(Signaling)
PTT ID XXXXXXXX Set PTT ID.
Table 5-9. Front Panel Programming Mode Parameters (Continued)
Main Menu
1st Level
Sub-Menu
2nd Level
Sub-Menu
Setting Remarks