Motorola MXP600 - Removing the VA Connector Seal

To Next Page

To Previous Page

NOTE: Use plastic tweezers to disengage the coin cell battery, ensure coin cell holder is

not dented or lifted-up.

7.4.20

Removing the VA Connector Seal

Procedure:

Remove the seal from the main PCB.

To view the video for removing VA connector seal, click Removing the VA connector seal

MN006362A01-AL

Chapter 7 : Radio Disassembly and Reassembly

110

Main Page

Default Chapter2
- Table of Contents2
List of Figures7
List of Tables8
Legal and Compliance Statements9
- Intellectual Property and Regulatory Notices9
- Compliance with RF Exposure Standards10
Safety Information12
- Electromagnetic Interference/Compatibility12
- Conformance Statement12
- Use of Communication Devices While Driving12
  - Operational Warnings13
  - Operational Cautions13
Document History14
- Table 1: Document History14
Notations Used in this Manual17
Chapter 1: Model Information18
- Model Specifications18
- Sales Model Nomenclature21
- Table 6: Model Numbering Scheme21
- Table 7: Sales Models - Description of Positions21
Chapter 2: Overview24
- Digital Modulation Technology24
- Voice Compression Technology24
- Transceiver24
- Bluetooth/Wlan Section26
- Global Navigation Satellite System (GNSS) Section27
- Figure 1: Bluetooth/Wlan Block Diagram27
- Figure 2: GNSS Block Diagram27
- Bottom and GCAI Connectors28
- Table 8: Logic Levels28
- Table 9: Bottom to BTB Connector29
- Figure 3: Mini GCAI Connector30
- Table 10: Mini GCAI Connector Pins30
Chapter 3: Programming the Radio31
- Figure 4: Sample of the TETRA CPS Plus Initializing Interface31
Chapter 4: Test Setup and Testing32
- Performing Typical Test Setup32
- Transmitter/Receiver Test35
- Configuring IFR 3901/IFR 3902/IFR 3920 Setup37
- Configuring IFR 2968 Setup38
- Configuring IFR 3901/IFR 3902/IFR 3920 Manual Screen Test39
- Configuring IFR 2968 Manual Screen Test40
- RF Tests40
- RTC Setup42
- Call Processing Tests43
- Digital Duplex Test (Transmitter) Using IFR 3901/IFR 3902/IFR 392044
- Digital Duplex Test (Transmitter) Using IFR 296845
- Assessing DALT Test45
  - Testing in DALT Mode46
  - Testing Charger Recognition54
Chapter 5: Maintenance56
- Preventive Maintenance56
- Safe Handling of CMOS and LDMOS Devices57
- General Repair Procedures and Techniques58
- Level 1 and Level 2 Maintenance59
- Table 12: Lead Free Solder Wire Part Number List59
- Table 13: Lead Free Solder Paste Part Number List59
- Protection of Static-Sensitive Devices60
Chapter 6: Replacement Parts61
- Replacement Parts List61
- Figure 8: MXP600 Exploded View 162
- Figure 9: MXP600 Exploded View 1 (for PMHN4457_, PMHN4462_)63
- Table 14: Replacement Part List 163
- Figure 10: MXP600 Exploded View 266
- Table 15: Replacement Part List 266
- Figure 11: MXP600 Exploded View 368
- Table 16: Replacement Part List 368
- Figure 12: MXP600 Exploded View 469
- Table 17: Part Replacement List 469
- Shelf Life Period70
- Accessories Replacement Parts List70
- Table 18: Shelf Life Period70
- Table 19: Antennas70
- Table 20: Batteries70
- Table 21: Carry Accessories70
- Table 22: Audio Accessories71
- Table 23: Chargers and Charging Accessories72
- Table 24: Programming Cable74
- Table 25: Miscellaneous74
Chapter 7: Radio Disassembly and Reassembly75
- Torque Specification Chart75
- Installing or Uninstalling the Microsd Card75
- Installing or Uninstalling the SIM Card79
  - Installing the SIM Card79
  - Uninstalling the SIM Card82
- Disassembling the Radio82
- Reassembling the Radio122
Chapter 8: Radio Leak Test162
- Vacuum Leak Test162
- Performing Leak Area Troubleshooting164
Chapter 9: Nfc/Secure Pairing Check167
- Programming the NFC Tag167
- Figure 15: NFC Programming Basic Setup167
- Table 28: Parameters of NFC Programming for Write Block169
Chapter 10: Service Information173
- Service Information173
- Service Information for APAC174
- Table 29: Service Information - Telephone Numbers and Addresses of the Asia and Pacific Motorola Solutions Centers174
- Recommended Programming Equipment176
- Table 30: Recommended Programming Equipment176
- Model Plates177
- Service Replacement Kit Matrix177
- Table 31: Model Plate177
- Table 32: Service Replacement Kit for MXP600177
- Table 33: Service Replacement Kit Matrix for Main Board179
Chapter 11: Service Aids181
- Table 34: Service Aids List181
Warranty and Service Support182
- Warranty Period and Return Instructions182
- After Warranty Period182
Glossary183

Motorola MXP600 - Removing the VA Connector Seal

Table of Contents

Other manuals for Motorola MXP600

Related product manuals