Figure 1: Bluetooth/WLAN Block Diagram
Enable
SDIO
Microcontroller
RF Conn
BT/WLAN
IC
Antenna
PMIC
Bandpass
filter
Switch
TCXO
38.4 MHz
The Bluetooth/WLAN path only consists of RF connector and bandpass filter that transfers the
Bluetooth/WLAN signal from the antenna into the IC.
The IC receives a 38.4 MHz reference frequency from TCXO to pull up the signal of BT_EN/WIFI_EN
from Dual Core Processor and subsequently enable Bluetooth/WLAN operation.
2.5
Global Navigation Satellite System (GNSS) Section
This section provides description on Global Navigation Satellite System (GNSS) in the radio.
The GNSS section contains the following components:
• GNSS Antenna
• GNSS Front Filter
• GNSS Chipset
Figure 2: GNSS Block Diagram
Microcontroller
Enable
I2C SDA
I2C SCL
IRQ
GNSS
GNSS
Antenna
Vehicular
Antenna
LNASAWVA Switch LNA
MN006362A01-AL
Chapter 2 : Overview
27