3 Connect the Vehicle Power Adapter (VPA) Charger accessory connector to the handset. Check
the following:
• LCD display shows charger connected.
• Keypad back-light is turned ON.
4 Connect the handset to the Desktop Charger. Check the following:
• LCD display shows charger connected.
• A beep is heard.
• Keypad back-light is turned ON.
• Charging icon is shown.
5 Connect the handset to the USB Charger. Check the following:
• LCD display shows charger connected.
• Three beeps are heard.
• Keypad back-light is turned ON.
• Charging icon is shown.
6 Connect the handset to the MUC Charger. Check the following:
• LCD display shows charger connected.
• A beep is heard.
• Keypad back-light is turned ON.
• Charging icon is shown.
7 Verify that the battery charger is in progress.
NOTE: The process advance is indicated on the Battery Strength icon.
8 Press the Power ON/OFF.
The radio turns OFF.
MN006362A01-AL
Chapter 4 : Test Setup and Testing
55
To Next Page
Loading...
