55
Routine Operation
Chillgard 5000
US
When the configuration changes have been saved, the "Settings" screen shows.
"Reset" Tab
Use the "Reset" tab to reset the point name and disable the point.
When the configuration changes have been saved, the "Settings" screen shows.
While the configuration is being updated, a "Busy" message
shows at the bottom of the "Point Configuration: Point #"
screen.
If the or button is selected while the "Busy" message
shows, a pop-up asks whether to abandon the configura-
tion changes.
• To return to the "Point" screen without saving the config-
uration changes, select "Return without Saving".
• To save the configuration changes and return to the
"Point" screen, select "Save and Return".
(1) On the "Point Configuration: Point #" screen, select
the "Reset" tab.
(2) Select "Reset".
(3) On the warning pop-up, do one of the following:
a) To return to the "Point Configuration: Point #"
screen without resetting the point, select "Cancel".
b) To reset the point name, disable the point, and
return to the "Settings" screen, select "Reset".
NOTE: If only one point is configured, it cannot be deleted.
At least one point must be configured for the system to
function. If an attempt is made to delete the only configured
point, a warning pop-up indicates that the action cannot be
completed.
Select "Cancel" to return to the Point Configuration: Point
#" screen.
To Next Page
Loading...
