56
Routine Operation
Chillgard 5000
US
7.8.4 Relay Configuration
Use the "Relay" option to change the relay configuration settings or test a relay.
NOTE: Except for the buttons that show in the screen headers, the screens and steps used to change
the relay configuration settings are the same as those used during the initial setup.
During the initial setup, the screen headers show the and buttons. During routine operation,
the screen headers show the , , and buttons.
When a change is made to the configuration, the "Save" button becomes active.
When the configuration changes have been saved, the "Settings" screen shows.
On the "Settings" screen, select "Relay".
To adjust the relay configuration settings, go to Section 5.4,
"Relay Configuration", and do Steps (1) through (5).
While the configuration is being updated, a "Busy" message
shows at the bottom of the "Configure Relays" screen.
If the or button is selected while the "Busy" message
shows, a pop-up asks whether to abandon the configura-
tion changes.
• To return to the "Configure Relays" screen without
saving the changes, select "Return without Saving".
• To save the changes and return to the "Configure Relay"
screen, select "Save and Return".
To Next Page
Loading...
