Cleaning
Cleaning the machine
10.06.2014 77
¾ Switch off the machine.
¾ Disconnect the machine from the mains electricity.
¾ Cover the mains plug with waterproof plastic bags.
¾ Close all stop-cocks in the supply lines.
¾ Allow the machine and sealing bar to cool down.
¾ Wrap up the empty new film pouches and store them outside of
the room in a clean and dry place during the cleaning procedure.
¾ Remove all waste (e.g. product scraps, film trim) on or around the
machine.
¾ Remove the following components:
– Sloping insert with with support angle.
– Filling plate.
– Sealing bar.
Cleaning and
disinfecting the
removed components
¾ Take the removed components to a separate room suitable for
wet cleaning.
To Next Page
Loading...
