Murphy EMS-GC10 - Page 179

Section 75 00-02-0878
2013-03-07 - 173 -
Event
Description
Notes
Eic Event
DPF Lamp OFF
Particulate filter is OK.
DPF Lamp ON (solid)
Indicates initial need for regeneration.
DPF Lamp ON (blink)
Regeneration is necessary
(after regeneration the lamp turns OFF).
DPF Active Regeneration not activated
(status)
Regeneration status.
DPF Active Regeneration activated
(status)
Regeneration status.
DPF Active Regeneration needed (status)
Regeneration status.
DPF Regen not needed (status)
Level of needed regeneration.
DPF Regen needed lowest level (status)
Level of needed regeneration.
DPF Regen needed moderate level
(status)
Level of needed regeneration.
DPF Regen needed highest level (status)
Level of needed regeneration.
DPF Regen not inhibited (lamp)
Regeneration switch is disabled.
DPF Regen inhibited (lamp)
Regeneration disable switch is active.
Automatic and manual regeneration cannot occur.
High Exh Syst Temp OFF (lamp)
Exhaust temp. below.
High Exh Syst Temp ON (lamp)
Exhaust temp. above.
Operators
Operator
Description
Notes
OR
Using OR between 2 events means that the output will activate when one of these
activates.
AND
Using AND between 2 operators means that the output will only activate if both
events are activated.
Outputs
Output
Description
Notes
Commands
Island
Function modes.
AMF
Peak shaving
Fixed power
Mains power export
Load takeover
Semi-auto
Running modes.
Test mode
Manual mode
Block mode
Lamp test
Activate lamp test (LED’s on display).
Ack. all alarms
Acknowledge all alarms.
Battery test
Activate battery test
Engine heater manual ctrl.
Force/release block of engine heater (this will
disable/enable the engine heater function).
Set to local start
Select local start in a power management application.
Set to remote start
Select remote start in a power management
application.
Set clock to 4 am
Set the device clock to 4 am/
04.00.
Set parameter 1
Choose a parameter set (nominal settings).