Murphy EMS-GC10 - Page 181

Section 75 00-02-0878
2013-03-07 - 175 -
Output
Description
Notes
Activate relay on
AOP-2 ID5
Activate buzzer on
AOP-2 ID1
Single AOP-2 buzzer.
Activate buzzer on
AOP-2 ID2
Activate buzzer on
AOP-2 ID3
Activate buzzer on
AOP-2 ID4
Activate buzzer on
AOP-2 ID5
Fan A running
Running feedback for cooling fans.
Fan B running
Fan C running
Fan D running
MB close inhibit
Inhibit the closing of MB.
Reset horn
Reset the horn relay.
Activate buzzer on controller
Activates the controllers internal buzzer
Deactivate buzzer on controller
Deactivates the controllers internal buzzer
Reset rel. counter
Set parameter 1
Select between parameter set 1 and 2 for BB nominal
settings.
Set parameter 2
M-Logic alarm 1
These are virtual alarms that can be used to trigger
M-Logic events. The alarms can also be set in the
digital inputs.
M-Logic alarm 2
M-Logic alarm 3
M-Logic alarm 4
M-Logic alarm 5
Act. Max ventilation
Activates max Ventilation.
De-act. Max ventilation
Deactivates max ventilation
Shutdown override
Activates shutdown override
Virtual Event Virtual event 1-32
These are used as interconnection between multiple
logics to enhance the possible number of events in
one sequence.
Relays
Selectable no. of relays are option-
dependent
The list will show all relays possible, including
optional ones. Make sure that a selected relay is
actually present.
Inhibits
Not used
-
Deactivate mode button
Mode button on display front.
Inhabit acknowledge in AUTO
If in AUTO mode, the alarm acknowledge is not
possible.
Inhabit Modbus commands
Modbus commands are ignored.
Inhibit 1
Alarm inhibits.
Inhibit 2
Inhibit 3
Activate mode shift
Shift from a running mode to
AMF in case of mains failure.
Deactivate mode shift
Inh. BTB close request
Bus tie breaker closing not allowed.
Block request for section
Use of section not allowed.
Inh. AOP1 buttons
All command buttons on AOP are ignored.
Inh. start button
-
Inh. stop button
-
Inh. GB button
-
Inh. MB button
-