Section 75 00-02-0878
2013-03-07 - 82 -
12. Remote MB ON
The mains breaker ON sequence will be initiated.
13. Remote MB OFF
The mains breaker OFF sequence will be initiated.
14. Remote alarm acknowledge
Acknowledges all present alarms, and the alarm LED on the display stops flashing.
15. Auto start/stop
The genset will start when this input is activated. The genset will be stopped if the input
is deactivated. The input can be used when the unit is in island operation, load takeover
and the AUTO running mode is selected.
16. Remove starter
The start sequence is deactivated. This means the start relay deactivates, and the
starter motor will disengage.
17. Generator breaker closed feedback (GB position ON)
The input function is used as an indication of the generator breaker position. The unit
requires this feedback when the breaker is closed or a position failure alarm occurs.
18. Generator breaker open feedback (GB position OFF)
The input function is used as an indication of the generator breaker position. The unit
requires this feedback when the breaker is opened or a position failure alarm occurs.
19. Mains breaker closed feedback (MB position ON)
The input function is used as an indication of the mains breaker position. The unit
requires this feedback when the breaker is closed or a position failure alarm occurs.
20. Mains breaker open feedback (MB position OFF)
The input function is used as an indication of the mains breaker position. The unit
requires this feedback when the breaker is opened or a position failure alarm occurs.
21. Emergency stop
The input shuts down the engine immediately. At the same time it opens the generator
breaker.
NOTE: The shutdown fail class must be selected.
22. Low speed
Keeps the genset running at a low RPM.
NOTE: The governor must be prepared for this function.
To Next Page
Loading...
