MUTOH XPJ-461UF - Page 130

130 Replacing absorption material for the flushing box
[7]
Remove the absorption material for the flushing box.
• Pull the tab up of the absorption material for the flushing box, and release
the hook.
Important!
When removing the absorption material for the flushing box, be
cautious of ink drops.
[8]
Attach new absorption material for the flushing box.
Note
Used absorption material for the flushing box should be put in a plastic bag, etc, and
dispose of it in compliance with local ordinance and instructions of local authorities.
[9]
Hold the position shown on the left and gently close the cover.
[10]
Tap [Enter].
• The message on the left will appear.
• That ends the procedure.
CRMaintenance
End   ー＞ Enter
CRMaintenance
Start   ー＞ Enter