MUTOH XPJ-461UF - Page 37

Loading media 37
[4]
Use the or to input the media width.
Tap [Enter].
Note
• These menu items will only appear if “On” is set for “Detailed-Set”.
• Any value from 30 mm to 483 mm can be set for the width.
[5]
Use the or to input the media length.
Tap [Enter].
Note
Any value from 30 mm to 329 mm can be set for the length.
[6]
• Use or to enter the PF (longitudinal) value.
• Use or to enter the CR (lateral) value.
•Tap [Enter].
Note
any value between the following range can be entered:
PF value: 0.0 to 309.0
CR value: 0.0 to 463.0
• The table will move inward.
• The carriage will move to the set position, with its LED pointer lit steady.
[7]
Check the position of the LED pointer.
• If it shows the correct position, tap [Enter].
• If it is not in the intended position, adjust the origin position as follows:
• Use or to move the table forward/backward.
• Use or to move the LED pointer leftward/rightward.
•Tap [Enter].
**:Width：
(30-483)   483mm
**:Length:
(30-329)   329mm
**:Origin:
 PF：0.0  CR：0.0
MovingTo
OriginPosition
**:Origin:
 PF：0.0  CR：0.0