MUTOH XPJ-461UF - Page 72

72 Set1: User Type
** > 6: Low Speed
Use this when you want a slower printing speed.
• It helps to enhance print quality when you print on an uneven surface media
or curved object (e.g. golf ball, ballpoint pen, smart phone case).
Setting values
The printing speed will not be lowered.
This is the default setting.
The printing speed will be lowered to
50%.
The printing speed will be lowered to
25%.
**>7: Show Edges
To check the printing area before printing, LED pointer shows where the image
will be printed on the media.
"Checking the printing area" P. 49
Setting values
LED pointer does not show the printing
area.
This is the default setting.
LED pointer shows where the image will
be printed on the media and the printer
will ask you at each point of corner if the
position is OK.
LED pointer shows where the image will
be printed on the media without checking
with the user.
Type**:6
LowSpeed
**:LowSpeed：
Off
**:LowSpeed：
50%
**:LowSpeed：
25%
Type**:7
ShowEdges
**:ShowEdges：
Off
**:ShowEdges：
Step
**:ShowEdges：
   Auto