MUTOH XPJ-461UF - Page 73

Set1: User Type 73
**>8: Obst. Detect
Selects the printer operation when the obstacle sensor has detected an obstacle.
Submenus
The printer cancels printing and prompts
the obstacle error message.
This is the default setting.
The printer pauses the printing and allows
users to choose from two options;
Print Continue or Print Cancel.
Note
• “Obstacle Detected Print Continue”
Hold the media flat on the table without any warp, fold or curl.
Tap [Enter] to resume the job.
• “Obstacle Detected Print Cancel”
Tap [Enter] to cancel the job and prompts the obstacle error message.
**>9: User Copy
This is for copying the currently selected User Type setting into another User
Type.
• The items that will be copied are: “Print Mode”, “Effect”, the “Confirm Print” and
“PF Adjust” adjustment values, “Vacuum Fan”, “MediaSetting”, “Low Speed”,
“Show Edges” and “Obstacle Detect”.
Setting values
Here you can select the User Type to copy
the settings into. If you select ALL, the
settings will be copied into all the User
Type.
**>10: Initialization
Returns all settings of the currently selected User Type to factory default.
Type**:8
ObstacleDetect
＊＊：ObstacleDetect:
   PrintCancel
＊＊：ObstacleDetect:
   Confirm
Type**:9
CopyUserType
**:CopyUseType：
  Type**->1
**:CopyUseType：
  Type**->ALL
Type**:10
Initialization