MUTOH XPJ-461UF - Page 78

78 Set2: Advanced
Pass Count
Sets the frequency that the printer spits ink from the print head.
• The head will carry out spitting operation every time it completes the number
of passes that you set here.
Setting values
<1 time> to 999 times
<> indicates the default setting.
Important!
If the number of spitting returns is set high, there is a higher chance of nozzle clogging when printing for a long time.
In such a case, print quality cannot be guaranteed.
Advanced Settings 7: Cleaning Type
Configure the settings for the auto cleaning (standby mode, during printing,
before print) and cleaning while in sleep mode.
Setting values
Consumes less ink than Normal cleaning.
Conduct nozzle check before and after
printing, and use when nozzle missing is
found.
Consumes more ink than Normal
cleaning. When nozzle missing still occurs
after Normal cleaning, conduct Long
cleaning.
Advanced Settings 8: Auto Cleaning
Set the auto cleaning to be performed while in standby mode, during printing,
before print, and by total print time.
Submenus
Standby mode
While Printing
Before Print
Accum. Print Time
Spitting：
On
PassCount：
(1-999)   1cnt
AdvancedSetting7
CleaningType
CleaningType：
Short
CleaningType：
   Normal
CleaningType：
Long
AdvancedSetting8
AutoCleaning
AutoCleaning1
StandbyMode
AutoCleaning2
WhilePrinting
AutoCleaning3
BeforePrint
AutoCleaning4
Accum.PrintTime