MUTOH XPJ-461UF - Page 77

Set2: Advanced 77
Advanced Settings 5: Header Dump
Sets whether to print the following information when printing.
(Required media size: width 250 mm × length 50 mm.)
• Data header
• Data dot number (printed only when Header Dump setting is ON)
• Printer serial number
• Firmware version
Setting values
Dump data is not printed.
This is the default setting.
Dump data is printed after the original
image is printed.
Prints only header dump.
“Data dot number” is not printed.
Note
• The data will be useful when contacting technical support.
• Performing printing if the printer is connected to PC, the print settings of RIP soft you are using are printed on data header.
Advanced Settings 6: Spitting
Enables or disables the spitting function while printing.
• The display will shift to setting of the pass count only if “On” is set for “Spitting”.
Setting values
Off / <On>
<> indicates the default setting.
Note
Spitting is a maintenance operation for preventing clogging of the print head’s nozzles. It consumes ink.
AdvancedSetting5
HeaderDump
HeaderDump：
Off
HeaderDump：
On
HeaderDump：
   Dump
AdvancedSetting6
Spitting
Spitting：
On