MUTOH XPJ-461UF - Page 76

76 Set2: Advanced
Layer Multi Strike3: Varnish Layer
Sets the number of times to print the same line in varnish layer (clear topcoat).
Setting values
<1 times> to 9 times
<> indicates the default setting.
Advanced Settings 2: Pass Wait
Sets the waiting time between passes in multi-strike setting and normal
printing.
Setting values
<0.0 sec.> to 5.0 sec.
<> indicates the default setting.
Advanced Settings 3: Head Travel
Sets up the range that Print head moves while printing.
Setting values
Print head moves the range of the print
data width.
• The print head will travel the maximum
distance possible with the printer.
Print head shifts within the media width.
This is the default setting.
Advanced Settings 4: Bottom Interlace
Sets the BottomInterlace function.
Setting values
Auto / <On>
<> indicates the default setting.
LayerMultiStrike3：
VarnishLayer
VarnishLayer：
(1-9)   1cnt
AdvancedSetting2
PassWait
PassWait：
(0.0-5.0)   5.0sec
AdvancedSetting3
HeadTravel
HeadTravel：
Data
HeadTravel：
   Machine
HeadTravel：
   Media
AdvancedSetting4
BottomInterlace
BottomInterlace：
On