124 Ramp
Ramp Stowage
NOTE: An audible chime will sound five times if shifting
out of park is attempted while the ramp is deployed.
1. Lift the ramp by the loops high enough to release the latches,
approximately 15 degrees above level. This will cause the
rollers on the ramp to start to drop down in the track and
release the cam locks and allow the ramp to retract.
2. Push the ramp back in until the storage latch clicks into
place. The fences on either side of the ramp will fold
down as the ramp as the ramp slides into the vehicle.
WHEELCHAIR LOADING
ALWAYS assist a passenger in a wheelchair with entering
and exiting during a short (both manual and power) deploy.
Assistance at all times is also is strongly recommended on
the long deploy.
REASON: The short deploy has a steeper angle than the
long deploy, which could make it more difficult to navigate
without assistance and could result in serious bodily injury or
death.
• The ramp should be checked to ensure it is free from
debris and has adequate clearance before loading.
Extra care should be used when entering and exiting in
inclement weather.
REASON: The surface of the ramp could become
slippery, which could make it more difficult to navigate and
increase the risk of injury.
NOTE: See the Seats and Safety Restraints section in this
manual for information on securing wheelchairs in the
vehicle.
To Next Page
Loading...
