Vehicle Controls 59
LIGHTS
Headlamp Control
Rotate the headlamp control knob clockwise to the first posi-
tion to turn on the parking lamps. Rotate clockwise to the
second position to also turn on the headlamps.
Autolamp Control
The autolamp system provides light sensitive automatic on-off
control of the exterior lights normally controlled by the head-
lamp control.
The autolamp also keeps the lights on for a predetermined
amount of time after the ignition switch is turned to off.
• To turn autolamps on, rotate the control to .
• To turn autolamps off, rotate the control to .
High Beams
Push towards the instrument panel to activate the high beams.
Pull the multi-function lever towards you to deactivate. The
indicator light in the instrument cluster will illuminate when
the high beams are activated.
Flash-to-Pass
Pull the multi-function lever towards you slightly to activate
and release to deactivate.
Daytime Running Lamps (DRL)
Your MV-1 is equipped with Daytime Running Lamps,
which turn on the headlamps with a reduced output under the
following conditions:
• the ignition must be in the RUN position,
• the headlamp control is in the OFF position, and
• the vehicle is in gear.
Always remember to turn on your headlamps at dusk or during
inclement weather. The Daytime Running Lamp (DRL) system
does not activate the tail lamps and generally may not provide
adequate lighting during these conditions.
REASON: Failure to activate your headlamps under
these conditions may result in a collision.
To Next Page
Loading...
