Seating and Safety Restraints 75
SEAT BELT WARNINGS
Seat belts are designed to bear upon the bony structure of
the body, and should be worn low across the front of the
pelvis, or the chest, shoulders and pelvis, as applicable;
wearing the lap section of the belt across the abdominal area
must be avoided.
Seat belts should be adjusted as firmly as possible,
consistent with comfort, to provide the protection for which
they have been designed. A slack belt will greatly reduce the
protection afforded to the wearer.
Care should be taken to avoid contamination of the webbing
with polishes, oils and chemicals, and particularly battery
acid. Cleaning may safely be carried out using mild soap and
water. The belt should be replaced if webbing becomes
frayed, contaminated or damaged.
It is essential to replace the entire assembly after it has been
worn during severe impact even if no damage is apparent.
Belts should not be worn with straps twisted.
Each belt assembly must be used by only one occupant; it is
dangerous to put a belt around a child being carried on the
occupant's lap.
No modifications or additions should be made which will
either prevent the seat belt adjusting devices or assembly
from operating to remove slack.
SEAT BELTS
Seat Belt Operation and Adjustment
ALWAYS wear seat belts. Buckling up will prevent injuries
and save lives.
REASON: The use of seat belts is essential to the safety
of all occupants. During an accident, a seat belt can help
prevent an occupant from being thrown against the inside of
the vehicle, thrown against other occupants, or thrown from
the vehicle. Seat belts also help restrain you and any
passengers during certain driving situations, such as hard
braking or rough terrain operation.
Your vehicle is equipped with combination lap and shoulder
belts for all seating positions. Seat belt and adjustment
instructions will be applicable to all vehicle seat belts.
If you do not have your seat belt fastened when the key is
turned to the ON or START positions, a seat belt reminder
chime will sound six times then the seat belt indicator light
will remain on solid until the seat belt is fastened.
If a seat belt is too short even when fully extended, seat belt
extenders can be purchased from your authorized MV-1 ser-
vice center. Seat belt extenders should be used only if the
existing belt is not long enough. When it is not required, it
must be removed and stored in a secure place.
To Next Page
Loading...