Seating and Safety Restraints 79
NEVER twist ANY part of a seat belt in ANY way.
REASON: A twisted seat
belt will not be able to use its full
width to take impact forces,
increasing the risk of injury in an
accident. If the seat belt is
twisted, try to straighten it out by
hand. If this does not work, have
it straightened by an authorized
service center.
ALWAYS remove ALL slack from seat belt.
REASON: During a collision, the upper body could move
too far forward, increasing the chance of head and neck
injuries.
Shoulder harness strap MUST fit snugly against the
shoulders and chest. Lap belt MUST fit snugly and as LOW
as possible across the hips, NOT across the waist.
REASON: Slack will be reduced and belt forces will be
applied properly on the chest and shoulder, reducing the risk
of injury in an accident.
Seat Belt Maintenance
Periodically inspect all seat belts for any noticeable damage.
Check all attaching hardware for security of mounting. Check all
retractors, latch plates, belt buckles, and release buttons for proper
operation. Inspect straps for rips, tears, or any signs of wear.
ALWAYS thoroughly inspect ALL seat belts straps, latching
mechanisms, retractors, and attaching hardware for damage
PRIOR to each use.
REASON: A frayed or torn seat belt strap may rip apart
during a collision. Damaged latching mechanisms, such as a
latch plate or belt buckle, will fail to hold during a collision. A
damaged retractor will not lock during sudden stops or
impact, and loose attaching hardware will not properly
secure seat belt components. All these conditions could
result in seat belt failure, resulting in serious injury.
If any damage is found, or you suspect that the seat belts are
not functioning properly, immediately have them checked at
an authorized service center.
To Next Page
Loading...
