Roadside Emergencies 137
3. Remove the jumper cable from the positive ( + ) terminal
of the assisting battery.
4. Remove the jumper cable from the positive ( + ) terminal
of the disabled vehicle’s battery.
After the disabled vehicle has been started and the jumper
cables removed, allow it to idle for several minutes so the
engine computer can relearn its idle conditions.
WRECKER TOWING
If you need to have your MV-1 towed, contact a professional
towing service, or if you are a member of a roadside assis-
tance program, your roadside assistance provider.
Your vehicle should be towed with a wheel lift or a flatbed.
CAUTION:
Do not have the vehicle towed with a
slingbelt.
REASON: Towing your MV-1 with a slingbelt could cause
damage to the front end of the vehicle. Also, towing with the
rear wheels on the ground will overheat or damage the
transmission, even when the vehicle is in neutral.
To Next Page
Loading...
