MV-1 PT019021 - Illuminated Entry

Introduction/Features 39
How to Reprogram your Remote Entry Transmitters
You must have all remote entry transmitters (maximum of
four) available before beginning this procedure. Any remote
entry transmitter that is not present during the programming
procedure will no longer operate the vehicle.
NOTE:
Ensure the brake pedal is not depressed during
this sequence.
To reprogram the remote entry transmitters:
1. Unlock all of the doors using the power door lock/unlock
control
2. Insert a key and turn the
ignition from the 1 (OFF)
position to the 3 (ON) posi-
tion then cycle between
those two positions eight
times in rapid succession
(within 10 seconds) with
the eighth turn ending in the
3 (ON) position. The locks will then lock and unlock to
confirm that the programming mode has been entered.
3. Within 20 seconds after the locks have cycled, you can
program a remote transmitter by pressing any button on
the transmitter. The locks will then lock and unlock once
to confirm that the remote transmitter has been pro-
grammed.
NOTE:
If more than 20 seconds pass before pressing a
remote transmitter button, the programming mode will exit
and the procedure will have to be repeated.
4. Repeat the previous step to program additional remote
transmitters. The locks will cycle once to confirm that
each remote transmitter has been programmed.
5. When you have completed programming the remote
transmitters, turn the ignition to the 1 (OFF) position or
wait 20 seconds. The doors will lock and unlock to con-
firm programming has been completed.
Illuminated Entry
The interior lights will illuminate when the remote entry sys-
tem is used to unlock the door(s) or sound the personal alarm.
The illuminated entry system will turn off the lights if:
• the ignition switch is turned to the ON position, or
• the remote transmitter lock control is pressed, or
• after 25 seconds of illumination.