NAiS GT10 - User Manual

Questions and Answers:

G
greenjohnSep 9, 2025
What does [Screen No. Error] mean on my NAiS Monitor and how do I fix it?
- D
  Dennis WardSep 9, 2025
  The [Screen No. Error] message on your NAiS Monitor can appear for several reasons: 1. Screen settings from the PLC, the GT main unit’s switch part, or the auto-paging indicate an unregistered screen number. 2. When bringing up the keyboard screen during data input, an unregistered keyboard screen number was specified. 3. GT configuration data and keyboard screen data exist in the GT main unit, but there is no base screen data. To resolve this, create and register screen content or specify the correct screen number. Create and register a keyboard screen or specify the correct keyboard number. Transfer base screen data from GTWIN.
E
ericbrownSep 12, 2025
Why is the buzzer sounding continuously on my NAiS GT10?
- K
  Kyle HobbsSep 12, 2025
  If the buzzer is sounding continuously on your NAiS Monitor, it means that Bit F of the first word in the basic communication area bit device is set to ON. To stop the buzzer, set the F bit to OFF on the PLC side. Do not use the basic communication area with ladder programs.
J
jonessharonSep 13, 2025
Why does the backlight color change or flash on my NAiS Monitor?
- S
  spencer57Sep 13, 2025
  If the backlight color changes or flashes on your NAiS Monitor, it is because Bits A and B, and Bit D, of the first word (backlight color setting) in the basic communication area bit device are set to ON, or Bits C and D (backlight flashing setting) are set to ON. To fix this, perform correct bit operations on the PLC side. Do not use the basic communication area with ladder programs.
C
Colleen MosesSep 15, 2025
Why does my NAiS GT10 Monitor take about 10 seconds to start after turning on the power?
- H
  Hailey GreenSep 15, 2025
  If nothing happens for about 10 seconds after turning on the power to your NAiS Monitor, it's likely due to a mismatch in communication conditions between the GT30 (COM. port) and the PLC. Verify the communication settings of both the GT30 and PLC, and ensure they are the same.
P
Paula HerreraSep 17, 2025
What does it mean when my NAiS GT10 displays [No Screen data]?
- A
  aguilarmichelleSep 17, 2025
  The message [No Screen data] on your NAiS Monitor indicates that there is no base screen data in the GT main unit, even when GT configuration data exists. To resolve this, transfer base screen data from GTWIN.