NARDA IDA - Page 91

5.3 Displaying and editing configuration data
Narda IDA-3106 83
Creating a new transmitter table
Main Menu • Settings • Transmitter Table
You must first create an empty table and then fill it up in order to create a
new transmitter table. Each transmitter in a transmitter table must be
defined separately by its center frequency and channel bandwidth, in
contrast with multi-channel tables. However, the separate frequency bands
in a Transmitter Table can also overlap.
Tip: The transmitter frequencies can be entered much more easily using the
marker in Spectrum mode. You can find information about this under
Adding individual frequencies to a Transmitter Table on page 84.
To create a new transmitter table:
1. Press the Create Transmitter Table softkey.
2. Enter a name and press OK to save it.
3. Select the new table using the rotary control knob and press the
Edit Transmitter Table softkey.
4. Press the Add Transmitter softkey to add a new transmitter, and make
the necessary settings using the available softkeys:
– Transmitter Name: Edit the transmitter name
– Fcent: Enter the center frequency
– CBW: Enter the channel bandwidth
– Antenna Polarization: Select the polarization (optional information)
– Directional Antenna: Select the antenna (optional information)
– Add Transmitter: Add a further transmitter
– Delete Transmitter: Delete the selected transmitter
– Sort: Sort the transmitters according to their names or center
frequencies
5. Press the ESC key to exit from the table.
Displaying and editing items in a transmitter table
Main Menu • Settings • Transmitter Table
1. Select a table using the rotary control knob and press the
Edit Transmitter Table softkey.
 The existing transmitters are shown as a list.
2. Press the ESC key to exit the menu without making any changes.
3. To edit the transmitters: Use the softkeys as described under Creating a
new transmitter table on page 83.
4. Press the ESC key to exit from the table.