NARDA SignalShark - Configuring the Measurement Performance (Config); Setting the Number of Spectrogram Frames (Sgram Frames); Setting the Number of Measurements (Scan. No); Setting the Measurement Sequence (Seq Mode)

Spectrogram View
101
Configuring the measurement performance
(Config)
Here you can define how measurements are performed.
 You selected the desired view.
1.
Tap the Config button.
2.
Then you can do the following:
Setting the number of spectrogram frames (Sgram Frames)
Here you can set the number of measured and displayed spectrogram lines.
To set the number of spectrogram frames:
1.
Tap the Sgram Frames button.
2.
Enter the number of frames.
3.
Tap the OK button.
4.
Press the Esc button to close the menu.
Setting the number of measurements (Scan. No)
Sets the number of measurements for a single run measurement until the measurement
stops.
It also affects the longtime detectors (MxP, MxR, ...).
To change the parameters:
1.
Tap the button and set the number of measurements either by using the rotary control
knob or by entering the value.
2.
Tap the OK button.
3.
Press the Esc key or tap the header to close the menu.
Setting the measurement sequence (Seq Mode)
Here you can set the following:
•
Single: Measurement stops after the number of scan count is reached.
•
Conti: Continuous measurement.
To change the parameters:
1.
Tap the toggle button to select Single or Conti.
2.
Press the Esc key or tap the header to close the menu.
Defining the stop behavior (Stop Mode)
The stop mode value changes the behavior of the measurement engine, after the Run key is
pressed.
•
Hold: Measurement continues in the background.
•
Stop: Measurement stops and runs again.
You can stop/hold the measurement using the Run key.