NARDA SignalShark - Lrange; Normal Range; Unit; Max. Probability; Min. Probability

Persistence View
93
Lrange
The Lrange button allows you to set the range of the y-axis.
To set the y-axis range:
1.
Tap the Display button.
2.
Tap the Lrange button.
3.
Enter the required value and tap the unit button.
 The setting is accepted immediately and the input window is closed.
4.
Press the Esc key to close the menu.
Normal Range
The Normal Range button allows you to reset Lmax and Lrange depending on the current
Reference Level. This is a good starting point for most measurements.
To set the Normal Range:
1.
Tap the Display button.
2.
Tap the Normal Range button.
 Lmax and Lrange are set immediately.
3.
Press the Esc key to close the menu.
Unit
The Unit button allows you to set the unit of the y-axis.
To set the y-axis unit:
1.
Tap the Display button.
 The menu opens.
2.
Tap the Unit button.
3.
Select the required unit from the dropdown list.
4.
Press the Esc key twice to close the dropdown list and the menu.
Max. Probability / Min. Probability
The Max. Probability and Min. Probability buttons allow you to set the probability borders.
In the diagram, the probability with which a signal is detected, is represented by colors:
•
Dark blue for value selected under Min. Probability: 0.00001% to 10%
•
Dark red for the value selected under Max. Probability: 0.0001% to 100%
To set Max. Probability and Min. Probability:
1.
Tap the Display button.
2.
Tap the Max. Probability or Min. Probability button.
3.
Set the Probability using the Rotary knob.
After using the rotary knob once the value can also be selected from the dropdown list.
4.
Press the Esc or OK key to close the dropdown list.