NARDA SignalShark - Setting the Lower and Upper Frequency Limits (Lower Freq. Lim.; Upper Freq. Lim.); Setting the Threshold (Threshold); Switching Limits on; off (Limits); Setting the Number of Measurements (Scan. No)

Peak Table View
111
Setting the lower and upper frequency limits
(Lower Freq. Lim. / Upper Freq. Lim.)
1. Tap the button to set the lower or upper frequency limit.
2.
Enter the required value and select a unit.
3.
Press the OK key.
Setting the threshold (Threshold)
1. Tap the button to set the threshold.
2.
Enter the required value and select the value prefix (+/-).
3.
Press the OK key.
Switching limits on / off (Limits)
⇒ Tap the button to switch limits on or off.
Setting the number of measurements (Scan. No)
Sets the number of measurements for a single run measurement until the measurement
stops. It also affects the longtime detectors (MxP, MxR, ...).
To change the parameters:
1.
Tap the button and set the number of measurements either by using the rotary control
knob or by entering the value.
2.
Tap the OK button.
3.
Press the Esc key or tap the header to close the menu.
Setting the measurement sequence (Seq Mode)
Here you can set the following:
•
Single: Measurement stops after the number of scan count is reached.
•
Conti: Continuous measurement.
To change the parameters:
1.
Tap the toggle button to select Single or Conti.
2.
Press the Esc key or tap the header to close the menu.
Defining the stop behavior (Stop Mode)
The stop mode value changes the behavior of the measurement engine, after the Run key is
pressed.
•
Hold: Measurement continues in the background.
•
Stop: Measurement stops and runs again.
You can stop/hold the measurement using the Run key.
To change these parameters:
1.
Tap the toggle button to select Hold or Stop.
2.
Press the Esc key or tap the header to close the menu.