NARDA SignalShark - Selecting a Filter Type; Setting the Resolution; EMC Bandwidth (RBW; EBW); Enabling;Disabling Oversampling (CBW Only); Setting the Video Time (Tvideo)

Level Meter View
79
Selecting a filter type
 You selected the desired view.
1.
Long tap the CBW / EBW button. (The displayed button label depends on the currently
selected filter type.)
 The context menu opens.
2.
Tap the Filter Type button and select the desired filter type from the dropdown list.
3.
Tap the head of the Button bar twice to get back to the main menu (or use the Esc key
instead).
Setting the resolution / EMC bandwidth (RBW / EBW)
Setting the bandwidth:
 You selected the desired view and set the desired filter type.
1.
Tap the CBW / EBW button.
2.
Set the bandwidth by rotating the rotary knob or enter the required value and select a
unit.
 The setting is accepted immediately and the input window is closed.
Enabling/disabling oversampling (CBW only)
 You selected the desired view and selected CBW as filter type.
1.
Long tap the CBW button.
 The context menu opens.
2.
Tap the Oversampling button to switch it On or Off.
3.
Press the Esc key to close the context menu.
Setting the video time (Tvideo)
To set the Tvideo value:
1.
Tap the header of the desired view.
2.
Tap the Tvideo button.
3.
Enter the required value and select a unit.
 The settings is accepted immediately and the input window is closed.
Setting the measurement time (Meas. Time)
Here you can set the measurement time. The measurement or detector time defines the time
range used by the internal detectors to calculate their values (+Pk, RMS, -Pk, ...).
To set the measurement time:
 You selected the desired view.
1.
Tap the Meas. Time button.
2.
Enter the required value and select a unit.
 The setting is accepted immediately and the dropdown list is closed.