NARDA SignalShark - Setting the Detectors (Detectors); Detector 1, Detector 2, Detector 3; Persistence; Changing Display Settings (Display and Tone)

Level Meter View
81
To change these parameters:
1.
Tap the toggle button to select Hold or Stop.
2.
Press the Esc key or tap the header to close the menu.
Setting the detectors (Detectors)
With the Detectors button, the three detectors can be set to a detector type or switched off.
Open the Detectors menu:
 You selected the desired view.
1.
Tap the Detectors button.
 The Detectors menu opens.
2.
Then you can do the following:
Detector 1, Detector 2, Detector 3
To select the detector types:
1.
Tap a detector and select from the dropdown menu:
–
Detector 1: +Pk, Off
–
Detector 2: RMS, Off
–
Detector 3: -Pk, Smp, Avg, Off
2.
Press the Esc or OK key to close the dropdown list.
3.
Press the Esc key to close the menu.
Persistence
To set the Persistence time value:
1.
Tap the Persistence button.
 The Persistence menu opens.
2.
Enter the required value and select a unit.
 The settings is accepted immediately and the input window is closed.
3.
Press the Esc key to close the menu.
Changing display settings (Display and Tone)
Here you can change general display settings such as the zero point of the Y-axis, the range
of the Y-axis or the axis unit (the available settings depend on the current view). In the lower
section of the Button bar you can enable tone search and change the tone search
configuration.
To open the menu:
 You selected the Level Meter view.
1.
Tap the Display and Tone button.
 The menu opens.
2.
You can now do the following