NARDA SignalShark - Changing General Display Settings (Display); Lmax

Spectrogram View
103
Changing general display settings (Display)
Here you can change general display settings such as the zero point of the Y-axis, the range
of the Y-axis or the axis unit (the available settings depend on the current view).
To open the Display menu:
 You selected the desired view.
1.
Tap the Display button.
 The Display menu opens.
2.
You can now do the following:
Lmax
Here you can do the following:
•
Set the zero level of the y-axis
•
Set the Entry Mode: Absolute or Relative
•
Set the Coupling: On / Off (not available in Level Meter view)
When coupling is set to On, the views of a task are coupled (e.g. the axis).
To set the zero level:
1.
Tap the Lmax button.
2.
Enter the required value and tap the unit button.
 The setting is accepted immediately and the input window is closed.
3.
Press the Esc key to close the menu.
Settings in the Lmax context menu
⇒ Long tap the Lmax button.
 The context menu opens.
Entry Mode
The Entry Mode button allows you to determine whether values are entered as absolute or
relative values.
To set the Entry Mode:
1.
Tap the Entry Mode button to select Abs. (Absolute) or Rel. (Relative).
2.
Press the Esc key twice to close the menus.
Coupling
The Coupling button allows you to couple the level axis of the views within a task.
Thus, Coupling is not available in the Level Meter view.
To set the Coupling:
1.
Tap the Display button.
2.
Long tap the Lmax button.
 The Context menu opens.
3.
Tap the Coupling button to switch coupling On or Off.
4.
Press the Esc key twice to close the menus.