NARDA SignalShark - Lrange; Normal Range; Unit

SignalShark User Manual
104
Lrange
The Lrange button allows you to set the range of the y-axis.
To set the y-axis range:
1.
Tap the Display button.
2.
Tap the Lrange button.
3.
Enter the required value and tap the unit button.
 The setting is accepted immediately and the input window is closed.
4.
Press the Esc key to close the menu.
Normal Range
The Normal Range button allows you to reset Lmax and Lrange depending on the current
Reference Level. This is a good starting point for most measurements.
To set Normal Range:
1.
Tap the Display button.
2.
Tap the Normal Range button.
 Lmax and Lrange are set immediately.
3.
Press the Esc key to close the menu.
Unit
The Unit button allows you to set the unit of the y-axis.
To set the y-axis unit:
1.
Tap the Display button.
 The menu opens.
2.
Tap the Unit button.
3.
Select the required unit from the dropdown list.
4.
Press the Esc key twice to close the dropdown list and the menu.