NARDA SignalShark - Setting the Detectors (Detectors)

SignalShark User Manual
102
To change these parameters:
1.
Tap the toggle button to select Hold or Stop.
2.
Press the Esc key or tap the header to close the menu.
Setting the detectors (Detectors)
Here you can do the following:
•
Enable/disable the detectors +Pk,RMS, Third Detector (detector depends on
Third Detector selection)
•
Select a third detector: +Pk; Avg, Smp
•
Select which of these detectors is displayed in the waterfall diagram
To open the Detectors menu:
 You selected the desired view.
1.
Tap the Detectors button.
 The Detectors menu opens.
2.
Then you can do the following:
+Pk, RMS, Third Detector
Here you can switch the three detectors on / off.
To switch a detector on / off:
1.
Tap the detector to switch it On / Off.
2.
Press the Esc key to close the menu.
Third Detector
For Third Detector following detector types can be selected:
•
-Pk
•
Avg
•
Smp
To select the Third Detector:
1.
Tap the Third Detector button.
2.
Select a detector from the dropdown list.
3.
Press the Esc key twice to close the dropdown list and the menu.
Visible Detector
The Visible Detector is the detector that is displayed in the diagram.
To select the Visible Detector:
1.
Tap the Visible Detector button.
2.
Select a detector from the dropdown list (only the enabled detectors are shown in the
dropdown list).
3.
Press the Esc key twice to close the dropdown list.