NARDA SignalShark - RF Parameters; Display; Connectivity; Power Supply

Introduction
21
RF parameters
⇒ For RF parameters please the data sheet.
Display
• Size 10.4”
•
Readable in sunlight
•
Resistive touchscreen, can be operated with gloves
Connectivity
SignalShark runs on Windows 10 and provides all connectivity of a PC:
•
USB 3.0 & 2.0: for keyboard, mouse, printer, hard disk, …
•
Display port: connect monitor, beamer, …
•
MicroSD: store results, ...
•
Ethernet: connect to your network, Internet, ...
Power supply
• The SignalShark has a long lasting dual battery pack:
•
2 x smart technology lithium-ion rechargeable battery pack
•
Hot-swappable (when using both battery packs) for interruption-free long-term
measurements.
However, operation is possible using only one battery back.
•
Batteries commercially available, Type: RRC2057, Li-ion, 48 Wh
•
Internal and external charging
•
Vehicle-adapter available
•
Operating time: approx. 3 hours (with 2 battery packs)
Additionally, it comes with a 100 V to 240 V external power supply.
Overview of options
The table below shows all the options available for the SignalShark. Your particular device
may not be equipped with all the options listed here and described in this online help.
Contact your local sales representative for advice or to order an option.
Table:
Available options
Option
Order number
Spectrum (scanned or real-time)
Shows signal level over frequency.
BN 3310/101
(included in
SignalShark Basic
Set)
Marker and Peak Table (of Spectrum)
List of relevant signal peaks in the measured spectrum.