Administration
119
Creating a backup image
Depending on the performance of your removable USB storage device, this process will
take at least 10 minutes.
1.
Open the Narda Recovery Environment as explained above.
2.
Plug in a removable USB storage device (recommended USB 3.0, min. 16 GByte, NTFS
formatted).
3.
Tap on USB Backup and Recovery.
4.
Tap on Capture Image.
5.
Tap OK.
6.
When the image is created, tap OK, then tap Reboot.
Recovering a backup image
1. Open the Narda Recovery Environment as explained above.
2.
Plug in a removable USB storage device (recommended USB 3.0, min. 16 GByte, NTFS
formatted).
3.
Tap on USB Backup and Recovery.
4.
Tap on Apply Image.
5.
Tap OK.
6.
When the image is recovered, tap OK, then tap Reboot.
Narda Recovery Stick
We recommend making a backup of the device system partition using the “Narda Recovery
Environment”. With this toolset, you can recover the system image in case of malfunctions. If
you missed to make a backup image or you cannot reach the “Narda Recovery Environment”
anymore, Narda offers a bootable, ready-to-use USB recovery stick.
NOTICE – Restoring the device from system image.
If you restore your device from a system image, it is a complete restoration of the system
partition (c:\). All actual system settings, files that has been stored on the system partition
and additionally installed applications including software options will be lost. Measurement
data is stored on the data partition (d:\) and will be not affected by this process. Although
the Windows license is still valid after the restore process, you may want to activate
To Next Page
Loading...
