Connecting Antennas and Cables
35
To connect the antenna:
The configuration data for the antenna have been uploaded.
1.
Connect the handle to the SignalShark (see Connecting the handle to the device).
2.
Connect the N-connector of the third party antenna to the antenna adapter. When you do
this, make sure that the antenna is screwed on to correspond with the polarization
direction shown on the adapter (i.e. antenna dipole position is in the direction of the
arrow).
3.
Connect the antenna adapter to the antenna handle.
The device will indicate the correct polarization H or V in Direction Finding mode (not
yet implemented).
4.
Select the antenna you are using.
The device remembers the last third party antenna that was used with the antenna
adapter and selects this automatically when it is plugged in. Check that the correct
antenna is displayed before making measurements.
To Next Page
Loading...
