NARDA SignalShark - Page 6

SignalShark User Manual
6
Selecting traces (Traces) ....................................................................................................... 70
Changing general display settings (Display) .......................................................................... 71
Lmax .................................................................................................................................. 72
Lrange................................................................................................................................ 73
Normal Range .................................................................................................................... 73
Unit .................................................................................................................................... 73
Level Meter View.....................................................................75
Available buttons .................................................................................................................... 75
Setting the reference level / attenuation value (Ref. Level / Attenuator) ................................ 76
Setting the reference level (Ref. Level) ............................................................................. 76
Setting the attenuator value (Attenuator) ........................................................................... 77
Settings in the context menu ............................................................................................. 77
Setting the tuner frequency (Ftune) ........................................................................................ 78
Setting the tuner frequency (Ftune) ................................................................................... 78
Setting the step width (Fstep) ............................................................................................ 78
Setting the channel / EMC bandwidth (CBW / EBW) ............................................................. 78
Selecting a filter type ......................................................................................................... 79
Setting the resolution / EMC bandwidth (RBW / EBW) ...................................................... 79
Enabling/disabling oversampling (CBW only) .................................................................... 79
Setting the video time (Tvideo) ............................................................................................... 79
Setting the measurement time (Meas. Time) ......................................................................... 79
Configuring the measurement performance (Config) ............................................................. 80
Setting the number of measurements (Scan. No) ............................................................. 80
Setting the measurement sequence (Seq Mode) .............................................................. 80
Defining the stop behavior (Stop Mode) ............................................................................ 80
Setting the detectors (Detectors) ............................................................................................ 81
Detector 1, Detector 2, Detector 3 ..................................................................................... 81
Persistence ........................................................................................................................ 81
Changing display settings (Display and Tone) ....................................................................... 81
Changing display settings .................................................................................................. 82
Using tone search (Display and Tone) ................................................................................... 84
Persistence View ....................................................................85
Available buttons ............................................................................................................... 85
Setting the reference level / attenuation value (Ref. Level / Attenuator) ................................ 86
Setting the reference level (Ref. Level) ............................................................................. 86
Setting the attenuator value (Attenuator) ........................................................................... 87
Settings in the context menu ............................................................................................. 87