NARDA SignalShark - Page 8

SignalShark User Manual
8
Defining the stop behavior (Stop Mode) .......................................................................... 101
Setting the detectors (Detectors) .......................................................................................... 102
Changing general display settings (Display) ........................................................................ 103
Lmax ................................................................................................................................ 103
Lrange.............................................................................................................................. 104
Normal Range .................................................................................................................. 104
Unit .................................................................................................................................. 104
Peak Table View....................................................................105
Available buttons ............................................................................................................. 105
Setting the reference level / attenuation value (Ref. Level / Attenuator) .............................. 106
Setting the reference level (Ref. Level) ........................................................................... 106
Setting the attenuator value (Attenuator) ......................................................................... 107
Settings in the context menu ........................................................................................... 107
Setting the measurement frequency (Fcent / Fspan, Fstart / Fstop) ................................... 108
Selecting the entry mode (Entry Mode) ........................................................................... 108
If Entry Mode is set to Fcent ............................................................................................ 108
If Entry Mode is set to Fstart ............................................................................................ 108
Setting the resolution / EMC bandwidth (RBW / EBW) ....................................................... 109
Selecting the filter type .................................................................................................... 109
Setting the resolution / EMC bandwidth (RBW / EBW) .................................................... 110
Settings in the context menu ........................................................................................... 110
Setting the measurement time (Meas. Time) ....................................................................... 110
Configuring the measurement performance (Config) ........................................................... 110
Setting the lower and upper frequency limits (Lower Freq. Lim. / Upper Freq. Lim.) ...... 111
Setting the threshold (Threshold) .................................................................................... 111
Switching limits on / off (Limits) ....................................................................................... 111
Setting the number of measurements (Scan. No) ........................................................... 111
Setting the measurement sequence (Seq Mode) ............................................................ 111
Defining the stop behavior (Stop Mode) .......................................................................... 111
Editing the peak excursion value (Peak Excursion) ......................................................... 112
Exclude low frequencies (Exclude LO) ............................................................................ 112
Selecting traces (Traces) ..................................................................................................... 112
Changing general display settings (Display) ........................................................................ 113
Administration ......................................................................115
Operating System ................................................................................................................. 115
System partitions ............................................................................................................. 115
User management ........................................................................................................... 115
Updating the operating system ........................................................................................ 116
Activating Windows .......................................................................................................... 117