NEC Univerge SV9300 Series - Table of Input Characters

DIAL BY NAME
(DIRECTORY SEARCH)
This feature is a common/personal directory
service which is supported by UNIVERGE SV9300
communication server. This feature allows a
terminal user to search desired party by name.
After searching the called party, the user can
originate a call to that party.
The feature is set to the terminal by system
data setting at initial installation. For details,
please contact the system administrator
.
The dialed numbers of common directory are
set by system data setting at initial
installation. For details, please contact the
system administrator
.
TO MAKE A CALL USING
DIAL BY NAME
1. Display the search screen.
• When using the System Speed Dialing,
press Soft key (DIR).
• When using the Station Speed Dialing,
• Press (Searching for
Directory).
MARY SMITH [200]
4:26 PM MON 11 MAY 2015
MIC DIR HIST. >>>>
2. Enter the characters of the name
that want to search.
Up to 4 characters can be entered for
keyword searching.
Please refer to “APPENDIX B INPUT
CHARACTERS” on page
102 for how to
enter the character.
NAME : SMIT
(ABC) ENTRY Common Person
3. Select the directory database.
(Common or Personal directory)
Press Softkey (Common) or Soft key
(Person)
•
Display example of when you pressed
Soft key (Common)
NAME : SMIT
(ABC) ENTRY Common Person
• Display example of when you pressed
Soft key (Person)
03:
Back ENTRY ↑P
rev ↓Next
When pressing Soft key (￪Prev) or Soft key
(￬Next) without entering the keyword, the
registered dial number or name is displayed
on the LCD in order.
4. Press Speaker key or to make a
call.
Y
ou will receive a dial tone.
Speaker key lamp lights red. →
Line key lamp lights green. →
81XXXXXXXXXX
JAMES SMITH
Recall PICK >>>>
5. Lift the handset to start a
conversation.
Speaker key lamp goes of
f. →
0:00:05 DDD
4:26 PM MON 11 MAY 2015
MIC Mute
DIAL BY NAME (DIRECTORY SEARCH)
95