MANUAL INTERCOM
The Manual Intercom groups have up to six
terminals sharing a common signal path. Users
can call other members of the Manual Intercom
group
by pressing a Manual Intercom feature key;
each press sends a tone burst over the speakers
of all the terminals in the group. When another user
answers the call a speech path is activated.
The feature key is set by system data setting
at initial installation. For details, please
contact the system administrator
.
TO INITIATE
1. Press Speaker key
.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Press Manual Intercom feature key
.
You will receive a ringback tone.
ICM 201
4:26 PM MON 11 MAY 2015
MIC DIR HIST. >>>>
3. Each press of Manual Intercom
feature key sends tone bursts.
TO ANSWER
1. While hearing ringing tone,
Manual Intercom feature key lamp flashes
green. →
You may receive a ring tone.
ICM 200
4:26 PM MON 11 MAY 2015
MIC DIR HIST. >>>>
2. Press Manual Intercom feature key
.
Manual Intercom feature key lamp lights
green. →
3. Press Speaker key
.
Speaker key lamp lights red. →
4. If called terminal is engaged in a
non-intercom call, the terminal may
press Manual Intercom feature key
after placing original caller on hold
(with Hold key).
FEATURE OPERATION
82
To Next Page
Loading...
