2. Press Line key that is placed on
hold.
Line key lamp lights green. →
201
4:26 PM MON 11 MAY 2015
MIC Mute
3. Lift the handset and return to the
held call.
It
is possible to retrieve a call on hold from another
terminal that has the same Line key flashing red.
IF UNANSWERED
After predetermined time, Automatic Recall
is initiated and the user hears Automatic
Recall ringer tone. Default time is one
minute.
Starting time to ring Automatic Recall is set
by system data setting at initial installation.
For details, please contact the system
administrator
.
HOLDING A CALL (USING
EXCLUSIVE CALL HOLD)
This feature allows a terminal user to place a call
on
Hold and to exclude all other station users from
retrieving the held call.
TO HOLD
Following explains to hold the call in progress.
1. While a call in progress,
Line
key that is used during a call lights green.
→
Line key on the other terminals lights red. →
201
4:26 PM MON 11 MAY 2015
MIC Mute
2. Press feature key
.
Feature key lamp lights red. →
3. Press Hold key
.
Line key that is placed on hold flashes green.
→
Line key on the other terminals lights red. →
Feature key lamp goes off. →
HOLD 201
4:26 PM MON 11 MAY 2015
4. Replace the handset.
FEATURE OPERATION
58
To Next Page
Loading...
