VOICE FIRST/TONE FIRST
This
feature allows incoming calls to your terminal
to either ring or go to voice announcement.
The feature access code/feature key is set by
system data setting at initial installation. For
details, please contact the system
administrator
.
TO SET VOICE FIRST/TONE
FIRST MODE
1. Press Speaker key
.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Dial V
oice First/Tone First access
code or press Voice First/Tone First
feature key.
LCD shows current mode.
You will receive a feature dial tone.
VOICE
4:26 PM MON 11 MAY 2015
Recall PICK >>>>
3. Dial any single digit ( - ).
V
oice First mode is switched to Tone First
mode (or vice versa).
You will receive a feature set tone.
TONE
4:26 PM MON 11 MAY 2015
Recall PICK >>>>
4. Press Speaker key
.
Speaker key lamp goes off. →
5. The called party can reply
.
WHEN A CALLED TERMINAL
HAS BEEN SET TO VOICE
FIRST
1. Press Speaker key
.
You will receive a dial tone.
Speaker key lamp lights red. →
Line key lamp lights green. →
2. Dial extension number
.
Wait for voice page alert tone.
VOICE CALL 200
4:26 PM MON 11 MAY 2015
R-TONE MIC
3. Speak to the called party
.
4. Dial
.
The called party's extension will ring.
200
4:26 PM MON 11 MAY 2015
R-TONE MIC
WHEN A CALLED TERMINAL
HAS BEEN SET TO TONE
FIRST
1. Press Speaker key
.
You will receive a dial tone.
Speaker key lamp lights red. →
Line key lamp lights green. →
2. Dial extension number
.
The called party's extension will ring.
200
4:26 PM MON 11 MAY 2015
R-TONE MIC
3. Dial .
W
ait for voice page alert tone.
VOICE CALL 200
4:26 PM MON 11 MAY 2015
R-TONE MIC
4. Start
conversation with called party.
5. The called party can reply.
FEATURE OPERATION
80
To Next Page
Loading...
