TRUNK QUEUING -
OUTGOING
This feature allows a terminal user
, upon
encountering a busy signal on a trunk, to set a call
and enter a first-in, first-out queue. As soon as an
outgoing trunk becomes available, terminals in the
queue will be called back on a first-in, first-out
basis.
This feature is set by Soft key or feature key.
The
feature key is set by system data setting
at initial installation. For details, please
contact the system administrator.
TO SET TRUNK QUEUING –
OUTGOING
This feature is available only for the terminal
that is set by system data setting at initial
installation.
1. Press Speaker key and dial the
outgoing access code.
Speaker key lamp lights red. →
Line key lamp lights red. →
The lines are all busy status.
You will receive a busy tone.
BUSY 26-255XX
4:26 PM MON 11 MAY 2015
CB
2. Press Soft key (CB) or T
runk
Queuing - Outgoing feature key.
You will receive a service set tone.
Outgoing feature key lamp lights red. →
3. Press Speaker key
.
Speaker key lamp goes off. →
Wait until the outgoing line is available.
SET 26-255XX
4:26 PM MON 11 MAY 2015
WHEN TRUNK IS AVAILABLE
1. Ringing of external incoming call is
heard.
Call Indicator Lamp flashes red.
Line key lamp flashes green. →
CALL BACK 26-255XX
4:26 PM MON 11 MAY 2015
Recall PICK >>>>
2. Lift the handset or press Speaker
key
.
Outgoing feature key lamp goes off. →
Call Indicator Lamp goes off.
Line key lamp lights green. →
3. Dial the desired number
.
81XXXXXXXXXX
4:26 PM MON 11 MAY 2015
Recall VOICE CB >>>>
TO CANCEL
This feature is available only for the terminal
that is set by system data setting at initial
installation. This feature cannot be canceled
by Soft key
.
1. Lift the handset.
Line key lamp lights red. →
200
4:26 PM MON 11 MAY 2015
Recall PICK >>>>
2. Press T
runk Queuing – Outgoing
feature key.
You will receive a service set tone.
Trunk Queuing – Outgoing feature is
cancelled.
Outgoing feature key lamp goes off. →
CANCEL
4:26 PM MON 11 MAY 2015
3. Replace the handset.
Line key lamp goes of
f. →
FEATURE OPERATION
70
To Next Page
Loading...
