NEC Univerge SV9300 Series - Day;Night Mode Change by Station Dialing

DAY/NIGHT MODE
CHANGE BY ST
ATION
DIALING
This feature allows selected terminals to activate a
change from day mode to night mode by dialing a
special code.
The feature access code/feature key is set by
system data setting at initial installation. For
details, please contact the system
administrator
.
1. Press Speaker key
.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Dial
Day/Night Mode Change access
code or press Day/Night Mode
Change feature key.
DAY
4:26 PM MON 11 MAY 2015
Recall PICK >>>>
3. Press - and set in various
mode.
•
Press
for DAY mode.
SET
4:26 PM MON 11 MAY 2015
• Press for NIGHT mode.
SET NIGHT
4:26 PM MON 11 MAY 2015
• Press for MODE-A mode.
SET MODE-A
4:26 PM MON 11 MAY 2015
• Press for MODE-B mode.
SET MODE-B
4:26 PM MON 11 MAY 2015
4. Press Speaker key
.
Speaker key lamp goes off. →
If a programmable key is used lamp
indication will be,
• Night Mode = Red lamp on
• Mode-A = Red lamp flashing (60 ipm)
• Mode-B = Red lamp flashing (120 ipm)
FEATURE OPERATION
89